wiring duct-RCCN » RCCN Cable Tie Gun Instructions for use http://www.wiring-ducts.com wiring duct-RCCN Wed, 01 Jun 2016 04:22:20 +0000 en-US hourly 1 http://wordpress.org/?v=3.5.1 RCCN Cable Tie Gun Instructions for use http://www.wiring-ducts.com/cable-tie-gun-instructions-for-use/ http://www.wiring-ducts.com/cable-tie-gun-instructions-for-use/#comments Sun, 04 Oct 2009 07:20:22 +0000 admin http://www.wiring-ducts.com/?p=3042

Cable tie gun for use: use:

TG-1,2,3,5,6 receiver are scales, scales representing corresponding strapping band width

TG-4 band placement head, pressing cutting.

TG-7~TG-8 will tie into an open slot on the head, the handle swings under tightening, fine handle pressing steel strip cutting, such as with the need of the hammer clamping buckle.

Hand tools are required artificial single placed bundling cut.

  ]]> http://www.wiring-ducts.com/cable-tie-gun-instructions-for-use/feed/ 0