Rail Cable Carrier
Due to the substantial friction, it is nearly impossible to realize travel lengths greater than 200 m. With the new rail cable carrier, the upper trough does not glide on the bottom trough, it glides on guide rails. Rollers are mounted on ball bearings at the side of the carrier. The guide rails come in the standard connection height. The cable trunking carrier does not sag. The tension and thrust is 90% less in comparison to gliding arrangements.
Quiet and low-vibration operation
The rollers run on wiring duct the guide rail and do not contact other rollers. Ball bearings and a polyurethane roller surface additionally contribute to quite and smooth operation.
Rail Cable Carrier Key Features
Save time and money with a minimum loop overhang
On the Rail Cable Carrier RCC – the driven connection is located at bend height. On gliding arrangements with a lower driver connection an extended loop overhang is required. This area cannot be used for travel.
RCC: Driver connection at bend height – minimum loop overhang
Long service life for the cable and cable carrier and longer service life for the cables
The carrier is subject to a minimum load which minimizes wear and optimizes the service life. RCC systems are especially gentle on cables since they are only bent at the bending radius of the carrier. There is no counter-bending as is used in gliding arrangements.